Belt Drive Pressure Washers are one of the most commonly used power washers in the industry. Their high performance and long-lasting parts make them a favorite of professionals. However, even the best equipment has problems from time to time.
It is, therefore, up to the content and knowledge you have to choose the best one. This article will guide you through that.
Below is a list of common problems with belt drive pressure washers:
- Drive Belts
The most common problem with belt-driven power washers is that the belts will become worn out over time. When the belts are worn out, they may slip out of place or break completely. It is important to replace worn belts immediately to avoid causing damage to your unit’s engine and other parts.
- Vibration
Another common problem is that the unit will vibrate more than it should when it is running at full speed. This can be caused by several different factors, including: worn/loose bearings on the crankshaft or flywheel; loose mounting bolts for engine/pump/motor mounts; improper spacing between crankcase halves (this space should be between .002″ and .005″ for most engines)
- Faulty engines
This is mostly brought about by old or contaminated fuel, dirty air filters, defective spark plugs, and blocked fuel vents. These are also the common causes for overheating and lack of power in engines.
Too high oil levels also play a role in uneven engine surges at idle. The latter could also be a result of low fuel in the level tanks.
What Are the Best Solutions for the problems in Belt Driven Pressure Washers?
Belt-driven washers are ideal when you need more power than a standard direct-drive electric or gas washer offers.
They are also great for folks who want to save space and don’t have room for two machines. Here are some of the best solutions for some common belt driven pressure washer problems.
1) The first solution is to replace the belt. You want to make sure you have the correct size and type of belt for your particular pressure washer model.
2) The second solution is to adjust the tensioner pulley on the tensioner side. A loose tensioner pulley can result in slippage. Just keep turning it clockwise until it has a tight grip on the belt and won’t allow it to slip when you turn on your pressure washer.
3) Change the oil filter every time you change the oil. It’s not difficult. In fact, it only takes a few minutes. All you have to do is carefully loosen the bolts on your pressure washer and remove the old filter. Then, replace it with a new one, and tighten the bolts back up. Make sure you don’t over-tighten them!
4) Engine Leaks Gas – If your engine leaks gas, check the fuel line connections to make sure they are tight and secure. Replace any damaged lines and tighten all connections until snug.
With the most common problems in these machines addressed, you have no reason not to get one of these. Visit the Giraffetools collections today for one of your own.
